Model Control Guide in FreeCAD

Hello friends welcome to FreeCAD tutorial in our previous tutorial we have learned How to Model Bevel Block in FreeCAD. In this tutorial we will do modeling of Control Guide with the help of Part design workbench of FreeCAD. You can also download my source file of the tutorial at https://mechnexus.com/mechnexus-youtube-tutorial-source-file/ so let’s start our tutorial.

Also Read-:

Also Read-:

Step by Step Guide to Convert below drawing into 3D Model -:

Select the top plane and create the below sketch.

Now extrude the above 68mm as shown in below image.

Now select the face and create the below sketch.

Now use pocket tool and remove the material.

Now select the face of the other side and create below sketch.

Now remove the material.

Now select the corner and give fillet of 13mm shown in below image.

Now give the fillet of 15mm as shown in below image.

Now give fillet of 6mm as shown in below image.

Now give fillet of 30mm as shown in below image.

Now create sketch hole as shown in below image and create hole.

Now create sketch hole and create hole.

Now next step is to create slot sketch.

Now create slot as shown in below image.

Now create the sketch for cut as shown in below image.

Now create the cut as shown in below image

“Thank you for reading! If you found this article insightful and valuable, consider sharing it with your friends and followers on social media. Your share can help others discover this content too. Let’s spread knowledge together. Your support is greatly appreciated!”