Model Offset Trip lever in FreeCAD

Hello friends welcome to FreeCAD tutorial in our previous tutorial we have learned Model Control Bracket in FreeCAD. In this tutorial we will do modeling of Model Offset Trip lever in FreeCAD with the help of Part design workbench of FreeCAD. You can also download my source file of the tutorial at https://www.mechnexus.com/mechnexus-youtube-tutorial-source-file/ so let’s start our tutorial. If you want to learn FreeCAD from scratch you can buy my The Complete FreeCAD Course : From Zero to Expert! on my Ko-Fi Shop. This Course is also available on Udemy at below link The Complete FreeCAD Course 2024: From Zero to Expert! but the dark side is that Udemy take 63% of revenue. I request to buy from my Ko-Fi shop It will help me a lot.

Also Read-:

Select the right plane and create the below sketch.

Now create the Pad of 80mm as shown in the below image.

Now create the datum plane at distance of 20mm as shown in the below image.

Now select the datum plane and create the below sketch.

Now create the pad of 10mm as shown in the below image.

Now select the edge and create the fillet of 6mm as shown in the below image.

Now select the edge and create fillet of 10mm as shown in the below image.

Now select the face and create the below sketch.

Now create the Pad of 15mm as shown in the below image.

Now select the face and create the sketch for hole as shown in the below image.

Now create the hole as shown in the below image.

“Thank you for reading! If you found this article insightful and valuable, consider sharing it with your friends and followers on social media. Your share can help others discover this content too. Let’s spread knowledge together. Your support is greatly appreciated!”